| Author | Message | ||
     Azbueller |
When I was replacing my belt I noticed the isolator was torn 1/3 the way around so I started calling around and only one dealer had them and there not a Buell dealer anymore. They wanted $40 a piece for them so I called Al at American Sport Bike and he sells the revised ones for 95-02 Buells so I ordered a set with hardware for $40!!! Well they don't fit my S2, has anyone put these on a S2 or tried to???  The originals look like this and are a H-D part.  The comparison picture.  | ||
| Mikej |
Someone posted about this in the last year or so, I think you have to trim something off to fit onto the S2's. | ||
| Spiderman |
You may have to grind down thoase tabs a tad but other than that It should bolt on. | ||
| Bluzm2 |
Side by side you have to remove the metal tab and reduce a bit of the rubber diameter on one side. It bigger and hits the the frame. I was going to put the new style on my S2 but used the old style instead. If you grind off the tab, be careful not to over heat them and melt thr rubber. Brad |
