|Posted on Wednesday, May 14, 2014 - 03:42 pm: ||
So I'm almost positive my ignition switch went dead. So... what wires can I put into a rocker (or toggle) switch to "short" so I can start the bike to get it home?
I can cut into it above the connector so I can replace the switch later but for now I'm stuck.
|Posted on Sunday, May 18, 2014 - 06:21 pm: ||
Open the connector up and lay a hunk of heavy gauge solder in there to short out all three wires. If the switch is shorted to ground use a piece of wood to hold the solder in the connector, if it is not just plug it back together.