| Author |
Message |
    
Sirvincentblack
| | Posted on Sunday, April 27, 2014 - 10:06 pm: | 
|
My 2006 uly xb12x has a new stator, New regulator, New battery (hd) New 77 connection. I get 18v at the 77 connector, I go to the battery and only find 12.2 volts. Ive checked the starter positive cable is tight. Both terminals are clean and tight. Grounds clean of paint and tight. Stator three pin connector looks good. What am I missing? |
Gabby_duck
| | Posted on Sunday, June 29, 2014 - 08:58 pm: |
|
Do you have an 06 service manual?page B-27 schematic clean the GRD2{ground)is the battery fuse good. Where the GRND from the battery goes to the frame is GRD2 . Pull the battery and remove and clean this area good then put dielectric on the clean connections .You shouldn't be getting 18 volts from the voltage reg. |
Sirvincentblack
| | Posted on Sunday, June 29, 2014 - 10:33 pm: |
|
Thank you. I found the rotor was rubbing the primary case. I ground that down and it is running. |
Akbuell
| | Posted on Monday, June 30, 2014 - 02:36 pm: |
|
"The rotor was rubbing the primary case"
If that started after the various bits were replaced, I would be looking very carefully at everything in the primary. If all of the parts are the correct ones, something is not assembled correctly. First thought is that the rotor nut is not correctly torqued.
In any case, the rotor should not be rubbing anything, much less need grinding down.
Dave |
|
Troubleshooting (Poor Starting/Running/Handling/Ride Issues) »
Archive through February 05, 2015 »
Charging issue