| Author | Message | ||
     Supermot |
09 xb12 starter button not working? Checked basics thought it was fuse but it looked good and i replaced it for good luck still nothing. is there another fuse inline that i am overlooking or a cut out switch i should check. anything would help thanks Tom 09 xb12 lightning long | ||
| Kalali |
Sorry if I am stating the obvious but make sure it is in neutral, the run switch is on and the ignition is on by physically confirming the bike does roll and headlight is on, etc. | ||
| Supermot |
yeah i tried all that i think it could be a bad sensor or something. i am pretty mechanical but i am stumped any other clues? | ||
| Sparky |
First of all do you hear a click coming from the Start Relay when you press the Starter Button? If yes, there is a small gauge wire on a blade quick-disconnect connector on the starter that comes from the Start Relay. Make sure that wire is connected to the starter. If no click, try pulling in the clutch lever while trying to start. The clutch switch should allow starting even if not in neutral or if the side stand is down. | ||
| Berto |
Had the same problem.The contact inside the start button had gunk on it. cleaned the contacts with sandpaper and works like new. | ||
| Supermot |
i tried alot of different stuff but it blows the light fuse when i hit the starter button. i have spent hours checking whites cleaning terminals. but they wont warranty it because i put exaust |
