Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Gohot
| Posted on Wednesday, May 28, 2008 - 02:17 pm: |
|
Ok, for the millionth time, zzzzzzzz I have the Buell Cyclone and of course the Rattels alot! can you replace JUST the center piece? the carrier? as oposed to getting the whole disk and carrier/w bolts& sprng washers, the reason I ask is ofcourse the cost of the whole unit, some $300.00 or so, and I know I'll get responces to replace the whole works, but I think at this point I can get one more run on the disk itself if I had a carrier that was new. Well thanks Rich |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Cheddarheads4erik
| Posted on Monday, July 14, 2008 - 10:58 am: |
|
Do you have the retaining spring clip in place, at the back of the pads? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Eshardball
| Posted on Saturday, July 19, 2008 - 10:11 am: |
|
I doubled up the spring washers on my lightning after the first replacement set were rattling in only 6K miles. Rotor still floats and doesn't rattle....yet. |
|