Author |
Message |
Bamaboy
| Posted on Saturday, April 05, 2008 - 10:10 am: |
|
I was getting ready to ride yesterday and had my rear plug foul. I took it out and cleaned it and reinstalled. The bike ran rough with the occasional backfire (sounded more like a 30-30) Anyway I got it up to speed for a few min and headed back home. When I stopped @ a red light the engine died. I pushed it off the road and noticed my ignition fuse was blown. I replaced it with the spare but no spark. I looked and it had blown again. Any suggestions?? |
Buell_bert
| Posted on Saturday, April 05, 2008 - 11:24 pm: |
|
What model first so someone can look at the wiring diagram. Although if it is blowing the ign. fuse most likely a ign. wire is shorting to ground. |
Bad_karma
| Posted on Saturday, April 05, 2008 - 11:40 pm: |
|
Patrick There is an S1 manual in BADWEB . Take a look. I would suspect wiring shorting out near the ECM. Joe |
Bamaboy
| Posted on Sunday, April 06, 2008 - 08:34 pm: |
|
my new bike is a 05 XB9SX |
Mookie
| Posted on Sunday, April 20, 2008 - 09:47 pm: |
|
i had this issue and it was due to something with my speedometer sensor. I unplugged it since i honestly dont pay that much attention. |
|