| Author | Message | ||
     Rarebird |
Anyone happen to know why the throttle side of my new Polly Heaters is so much warmer than the clutch? It would seem the extra material of the throttle sleeve would make it cooler, but this is definitely not the case on my Uly... Is there a way to "even out" the temps? I had the mylar style on my 'Bolt, which worked very well, but they had a specific left and right heater to give nearly even temps. Thanks! -Mike | ||
| S_palmer |
Mine heat very evenly, are you sure you have them wired right? | ||
| Rarebird |
That was my first thought: I've wired them per the instructions, checked and re-checked thinking I might've wired the high on one with the low on the other, but everything looks correct. | ||
| Metalstorm |
Maybe the insulation got pushed away from the heater on the clutch side? Mine heat evenly. I can't remember if the pollys were side specific but I don't think they were. I made absolute certain that the insulation was where it was suppose to be when I installed them. |
