Author |
Message |
Torquemonster
| Posted on Thursday, October 04, 2007 - 11:56 am: |
|
Looking to swap 7 degree down bars - and just the bars, not the plate- from tuber crossroads for the zero degree bars from a set of XB crossroads. Wondering if the measurements of the channels are exactly the same... Buell gods, what say ye? |
Al_lighton
| Posted on Thursday, October 04, 2007 - 09:39 pm: |
|
The -7 degree bars on the tubers are the same on all except the M2, which uses longer bars. The XB -7 bars are the same as those as well. The XB zero degree bars have the same interface into the plate, but are at 0 degrees instead of -7 (duh). But the bar itself is approximately .7 inches shorter. This could be a problem on a tube frame unless it has the small tank at full lock, as the switch pods will likely hit the tank. Al |
Torquemonster
| Posted on Friday, October 05, 2007 - 03:25 pm: |
|
Thanks Al. |
|