Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Gooseman
| Posted on Friday, February 02, 2007 - 09:50 am: |
|
Converting a 99 X1 to carb and was hoping someone that had done this before could point me in the right direction about how to re-wire to accept the new ignition module (Crane Hi4E) gOOseman |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ryker77
| Posted on Friday, June 22, 2007 - 09:10 am: |
|
You'll need a new timing cup, aftermarket igntion module with correct coil. Then just follow the instructions from the ignition kit.. The ECM is just by-passed or removed. |
|