|Posted on Tuesday, March 28, 2006 - 08:45 pm: ||
Will mikuni part no. khs-020 work for a 98 s3? See link:
|Posted on Tuesday, March 28, 2006 - 09:56 pm: ||
Yes they will.
Do you plan to reroute the breathers to a catch can?
|Posted on Wednesday, March 29, 2006 - 12:47 am: ||
Are you sure? The reason I ask is that if the nipples swivel as the bolt goes in, it may not be possible to thread them in with the engine in the frame. I seem to recall cutting one of my (non-mikuni) right angle nipples off as the easiest way of unscrewing them when I replaced them with banjo bolts.
If the nipples don't swivel as the bolt is threaded in, or you know that they are short enough, never mind.
|Posted on Wednesday, March 29, 2006 - 11:36 am: ||
The Mikuni tech stated the KHS-020 bolts are 10mm. They're the "old" style that swivels. 10mm should fit? If I'm able to get a good seal I'll use them b/c I the bolts' look.
Brad and Al,
My set-up will be the mikuni bolts, 5/16" hoses from the bolts routed to a tee, then a 3/8" hose from the tee around the battery and ending near the end of kickstand when it's elevated. The junk will mist into the air.