| Author | Message | ||
     Ingemar |
Does anyone know if Buell has sent out some sort of bulletin that corrects step 11 on page 1-48 of the xb9r service manual? Some dealer claimed to have received this, and it should correct the 5.2-5.6 degrees angle to 5.8 degrees in the TPS reset instructions. If anyone has a 2004/2005 service manual, can you check what your manual says? Thanx! | ||
| Spiderman |
The TPS should be set at 5.8 | ||
| Fullpower |
it is not terribly relevant. just establishes an approximate idle postion for the throttle plate, that is a default position likely to start and run, after which the idle can be set by RPM when engine is warm. | ||
| Dcmortalcoil |
Mine is set at 4.9 degrees after adjusting the idle. | ||
| Morts |
Mine was set at 3.4 and they said it was the lowest they had seen. What does this mean .....is it a bad thing? it runs great, but im interested at what they are talking about. Morts | ||
| Ingemar |
Yeah, it seems that in most cases you need to turn your idle screw out after the procedure, so in the end your tps should read less than the specified 5.2-5.6. That's why I wonder why that dealer insisted it was 5.8, as instructed by Buell. It's nonsense I know, but if his bulletin was real (I didn't see it) I just like to know about it that's all. | ||
| Buckinfubba |
it used to be 5.8 but they put out a bulletin saying to start at 5.2 to 5.6 notice I saisd start at those numbers it can vary | ||
| Ingemar |
Thanks Brian. |
