|Posted on Thursday, August 04, 2016 - 02:51 am: ||
Greetings folks, first post but a long time visitors to this site.
Doing a transplant using a BUELL XB12 motor in a different chassis,
Due to backbone interference, I wanted to run the throttle body at 90 deg for sidedraft.
I have seen Bottpower do this,
After putting the throttle body in the desired position, I faced a whole set of new problem, how to tighten the retainer ring screws was one...
Any insight or anyone done this?
|Posted on Thursday, August 04, 2016 - 06:21 pm: ||
Use a x1 or s3 intake/throttle body.