G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » XBoard » Archive through November 05, 2012 » New battery, fully charged, barely turns over and voltage sags « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Saturday, October 27, 2012 - 11:33 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

OK, so I have a brand new Scorpion battery fresh off the charger with what the charger says is 100% charge. Hit the starter button and here is engage and try to turn the motor then clicking from not enough voltage. Hit it again and it turns over and fires. Volt meter shows going up to 14 volts while riding. Stop to air up the tires after riding a bit, hit the starter and barely turns over with again wicked low voltage. Run to gas station to fill up tank and voltage never made it back up to the nearly 14 volts. Fill tank and it starts a little better but still low voltage, now showing 14 volts when riding.

So do I have a brand new AGM battery that is dead or do I have a starter that is wrecking batteries? Need to pull battery and see if I can get a load test somewhere.
Top of pagePrevious messageNext messageBottom of page Link to this message

Glitch
Posted on Saturday, October 27, 2012 - 11:48 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Sounds like the starter is dragging, unless of course you ended up with a bad battery.
VR and stator are alright I take it.
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Sunday, October 28, 2012 - 12:28 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

VR is new about 300 miles ago and I assume stator is fine since it produces the correct voltage.

Going to either get an auto store to load test it or buy a 100 amp load tester soon. This battery now has about 15 miles on it so it is essentially still brand new.
Top of pagePrevious messageNext messageBottom of page Link to this message

Panhead_dan
Posted on Sunday, October 28, 2012 - 09:21 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Sounds to me like you need to clean some grounding points. Might as well clean the hot side too.
Top of pagePrevious messageNext messageBottom of page Link to this message

Buford
Posted on Sunday, October 28, 2012 - 10:57 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Yeah, sounds like a grounding issue maybe? My new Scorpion spins the XB over really well. No more clock resets etc.
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Sunday, October 28, 2012 - 12:28 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

That's why I bought that battery. The hot side is good but I'll need to check the ground points and make sure everything is OK. It was working fine until I changed the break in oil to synthetic back in May and then I started having problems.
Top of pagePrevious messageNext messageBottom of page Link to this message

Djohnk
Posted on Sunday, October 28, 2012 - 04:32 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Yup, those grounds on the XB's are finicky.
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Sunday, October 28, 2012 - 06:14 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Bought a Schumacher BT-100 100 amp heater (load tester) and this battery definitely tests bad. The needle never holds a spot. I also tested my old Harley battery that I thought was going bad, even after sitting two months I got a sustained 400 CCA rating. Did this three time with the same result. Came back 30 minutes later and did it again with the same result. Put it back on charge and probably just going to put it back in.

Need to check grounds and if it still has trouble then it will be time for a new starter motor.

So where are the important grounds? I need battery to frame. Frame to engine up on top where the upper strap bridges the frame and isolation mount. Where else do I need to clean?
Top of pagePrevious messageNext messageBottom of page Link to this message

Panhead_dan
Posted on Sunday, October 28, 2012 - 06:42 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

There are threads about this already here but what I did is to remove the battery and the cables. I saw where the cables attach and then examined how that part makes connection with the next part, took those apart and cleaned them and so on, cleaning connections all the way there. Depending on your model, the routes may differ from mine, I have no idea.

One other thing I did was to run a heavy gauge wire from batt neg to one of the through bolts on the starter. Haven't cleaned the battery box connection or the frame ground since. Been about 4 years now.

(Message edited by panhead_dan on October 28, 2012)
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Sunday, October 28, 2012 - 06:53 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

The additional ground cable makes a lot of sense and I'll probably do this too, especially if I need to replace the starter.

Everything is going to get a coating of CorrosionX when it goes back together too.

Specifically I have a 2003 XB9R
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Monday, November 05, 2012 - 09:11 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

New battery holds at about the 1000CCA position with the above tester. Haven't tried to start it 'cause it was miserable last weekend and it's cold now. Probably won't get it running again this year.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration