G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » XBoard » Archive through May 07, 2012 » Oil light, bike shut down, lean rear « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Cpatt
Posted on Tuesday, March 20, 2012 - 01:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Ok I was riding 2 days ago about a 90 mile ride. Arroubd 80 out. We stopped for a min and when we went to leave bike started when 20 yards then shut down oil light was on b4it shut down. So we stopped,let it cool 20 min and she started and ran fine. It did it again about 20 miles down tge road.

I have pleanty of oil
I pulled the plugs yesturday and the rear was lean

Whats the best way to go about fixing this its an 04 xb12r with an 06 engine. It has a jardine ehxaust abd I remapped the.ecm.

Ill post pics of the plugs when I get home
Top of pagePrevious messageNext messageBottom of page Link to this message

Glitch
Posted on Tuesday, March 20, 2012 - 02:48 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

The oil light will not indicate fouled plugs.
Sounds like you've a circulation issue if the oil light's on, and you're full of oil.
Maybe your oil filter has gone bad.
Maybe your oil vent is clogged.
Maybe you just need to change your oil.
I just doubt your spark plugs have anything to do with the oil light coming on...
Top of pagePrevious messageNext messageBottom of page Link to this message

Ericz
Posted on Tuesday, March 20, 2012 - 05:02 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Those oil pressure switches like to act goofy sometimes. Verify the switch operation too!
Top of pagePrevious messageNext messageBottom of page Link to this message

Cpatt
Posted on Tuesday, March 20, 2012 - 05:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

i had assumed that it was lean and over heated making the oil to thin for the pump to move it.

i put new oil in it the other day. coudlnt do the filter because my local auto parts store didnt have one.


the oil light. if that comes on will the bike instantly start to low idle and die?

the light goes off after like 10 min of it sitting and the bike cools a little.

i appreciate the help guys. its riding weather and i wanna ride.
Top of pagePrevious messageNext messageBottom of page Link to this message

Cpatt
Posted on Tuesday, March 20, 2012 - 05:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

oh and the other thing pointing me to an overheating problem. is that in the morning it was 48 today and it ran fine made it to school. but i didnt make it home today in the 75+degree weather. thats why i think it has something to do with temperature.
Top of pagePrevious messageNext messageBottom of page Link to this message

Glitch
Posted on Tuesday, March 20, 2012 - 07:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

coudlnt do the filter because my local auto parts store didnt have one.
Find one.
There's a bypass valve in the bottom of the filter that needs to work properly.
If the rider before you used an automotive filter, there's an even more chance of something going wrong, do not use an automotive filter!
If the bike overheats, it'll go into "skip mode" making the bike run on one cylinder.
It would also cause the engine light (not the oil light) to come on, thus throwing a code.
Do you have a service manual to show you how to check codes, and their meaning?
If you don't, get one.
These bikes not having anyone wanting to work on them leaves us to do the work.
A service manual is a must have, a big must have.
Top of pagePrevious messageNext messageBottom of page Link to this message

Cpatt
Posted on Tuesday, March 20, 2012 - 08:29 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

i have a service manual and ecm spy. remapped my ecm with the race map. i went and found an oil filter. what a pain... and its a fram for bikes.
ill be putting it on tomorrow along with an oil pressure switch that i no is working properly. then im going to drop the oil pump just to be sure its not screwed up.. if it is ill put in the one from the bad engine.

from what your telling me im not over heating then. it never when in to "skip mode" and the engine light never came on.

i have no codes coming up when i check them with ecm spy.


and just another question what wire goes to what injector on the throttle body. theres a green and a white. i didnt notice it when i put the new engine in but would like to make sure i have that right.

(Message edited by cpatt on March 20, 2012)
Top of pagePrevious messageNext messageBottom of page Link to this message

Glitch
Posted on Wednesday, March 21, 2012 - 07:09 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

ill be putting it on tomorrow along with an oil pressure switch that i no is working properly.
There is your problem.
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Wednesday, March 21, 2012 - 09:42 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I want to say Gray/yellow is front but I might have the colors wrong.
Top of pagePrevious messageNext messageBottom of page Link to this message

Firemanjim
Posted on Wednesday, March 21, 2012 - 02:26 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

You would know if you had the injectors crossed,trust me!
Any change in AFV?
Top of pagePrevious messageNext messageBottom of page Link to this message

Cpatt
Posted on Wednesday, March 21, 2012 - 02:28 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

No my afv is 100% when I check it yesturday. I figured if I had them crossed the rear would just run lean.
Top of pagePrevious messageNext messageBottom of page Link to this message

Cpatt
Posted on Wednesday, March 21, 2012 - 06:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

ok just changed the filter checked the pump and replaced the switch. all seems good. tomorrow will be the test see how far she goes
Top of pagePrevious messageNext messageBottom of page Link to this message

Greg_e
Posted on Thursday, March 22, 2012 - 01:25 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

white/yellow is front, green is rear injector.
Top of pagePrevious messageNext messageBottom of page Link to this message

Cpatt
Posted on Thursday, March 22, 2012 - 06:08 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

i figured it out i think guys. the fuel pump. i think its gone.

or when it heats up it just give me a big middle finger and hates life.

(Message edited by cpatt on March 22, 2012)
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration