| Author | Message | ||
     Dthquazi |
Search is still down. 2009 xbscg 1125 cr bars with cable routed through headlamp housing. I have gotten my bike put back together and am at the point of adjusting the clutch. At the tightest point of adjustment, I still can't get the spec range required by the manual. Anybody with this setup or better knowledge than me have any suggestions. Was rolling the bike around and it is tough to roll when in first gear with the clutch lever pulled (engaged disengaged, can't remember which). I can roll it but it takes some leg power. Bike went through a complete clutch rebuild due to a low side. |
