Author |
Message |
Skatefaster
| Posted on Monday, October 26, 2009 - 12:35 am: |
|
So I decided to wrap my headers this weekend and after rotating the engine back into place, she just isn't runnin right. It sounds like it's starved for gas. I thought this would go away if I let it run for a bit because I disconnected the fuel pump to rotate the engine. But after a few minutes it still isn't right. It sounds like it is running on a really low idle and I have to open the throttle to keep it runnin. I even tried to hop on and take her for a ride but there is no power. Almost like it's only runnin on one cylinder. I'm guessin that somethin I disconnected during the engine rotation didn't get reconnected. I'm gonna check all the wires and check the plugs as well. Anybody got any suggestions about what else to check? I won't get to work on it til tomorrow. |
Tgblxb
| Posted on Monday, October 26, 2009 - 10:37 am: |
|
try riding it in the learn mode and see if it will reset. i don't remember what rpm it learns at though. hopefully someone else will chime in. you may need to get the tps reset though. |
Froggy
| Posted on Monday, October 26, 2009 - 10:59 am: |
|
If your on one cylinder, only one header pipe will get warm. |
Firstfamily
| Posted on Monday, October 26, 2009 - 11:19 am: |
|
3000 rpm for about 10 to 15 minutes/miles for the ecm to relearn. |
Skatefaster
| Posted on Monday, October 26, 2009 - 11:56 am: |
|
Found the problem. I forgot to plug in the rear injector. Thats what I get for putting things back together in a rush and in the dark. Thanks for your help guys! |
Neilgehrke
| Posted on Monday, October 26, 2009 - 12:14 pm: |
|
Yah that would do it. |
Andymnelson
| Posted on Monday, October 26, 2009 - 12:36 pm: |
|
mmm hhmm, I can see that causing your bike to run a bit rough. |
|