| Author | Message | ||
     Tq_freak |
The turn signals stopped working on my 12S this week and was trying to figure it out. Well I pulled the pins out of the connector for the flasher to check for corrosion / wire breaks and told my self "don't forget the order" well I did. If some one could just take a snapshot of a diagram of which wire goes where I would be more then appreciative. Side note, I figured it out, the LED flasher went bad. No wire breaks and every circuit has continuity. Flasher stops / Stars working when wiggled . | ||
| Blake |
I had that one nailed from the start. Good you figured it out too.  |
