| Author | Message | ||
     Carparts009 |
Has anyone ever used them? I think the rear will fit fine but I don't know about the front. It comes with four pins for the steering neck but I don't know if any of them will fit on the XB. | ||
| Cmhxb9 |
I've used a set for over 2 years. They work very well! I even perform maintenance with my '03 XB9S set up on them. I recommend 'em. Hints: 1) If you're going to remove the rear wheel, make sure you position the rear stand's right-most swingarm bracket in front of the axle's pinch fastener. 2) If you need to work with the rear belt guard, remove it prior to setting the bike on the rear stand. | ||
| Carparts009 |
so a pin that is included with the front stand works...I'm hoping these will work so I can use them on the XB and the R6 | ||
| Cmhxb9 |
Oh yeah...one of the included pins does work. | ||
| Diablobrian |
One of the pins works, but is a little small. I turned one of the large ones down a bit on my lathe to make it fit better, but it wasn't something I had to do. I've been using the same front stand (under the triple) for >5 years now. I never tried to use the LP rear stand on my XB (also mine has spools on it) | ||
| Carparts009 |
Awesome thanks guys |
