G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Motorcycle Forum » XBoard » Buell XBoard Archives » Archive through July 14, 2006 » Re-ringed motor « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Sgthigg
Posted on Sunday, July 09, 2006 - 12:21 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

How should I re-break in my motor. I had 9600 miles on my xbs and had the base gaskets replaced. The rings were also replaced. How should I rebreak in the motor?
Top of pagePrevious messageNext messageBottom of page Link to this message

Firemanjim
Posted on Sunday, July 09, 2006 - 02:50 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Give it a couple of heat cycles and go.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sgthigg
Posted on Wednesday, July 12, 2006 - 02:30 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Thats it??

Well Did that already..

Thanks
Top of pagePrevious messageNext messageBottom of page Link to this message

Buellistic
Posted on Wednesday, July 12, 2006 - 09:11 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Fans blowing on both sides on engine ...

MINUTES--MAX.RPM--HEAD TEMP.(DO NOT EXCEED)
1/2========4K=======160 Degrees(365F)
1==========5K
1 1/2=======5K
2==========5K
2 1/2=======6K
3===========6K
3 1/2=======1500/1900 IDLE
4===========1500/1900 IDLE
Top of pagePrevious messageNext messageBottom of page Link to this message

Spatten1
Posted on Wednesday, July 12, 2006 - 09:15 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

What did they say the cause of the base gasket leak was? Mine is seeping oil now.

Someone on this board said it is from driving hard without being fully warmed up.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sgthigg
Posted on Wednesday, July 12, 2006 - 01:40 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Spatten, They didnt say what caused it. They just took her in and did the work. Mine seaped and I ALWAYS ALWAYS ALWAYS let mine warm up for 4-5 mins idle and the ride very easy till she completely warms up. I think it just the nature of some of these beasts.

Spatten if your is still underwarranty I wouldnt accept theyre response for what caused yours to seap if you let yours warm up.
Top of pagePrevious messageNext messageBottom of page Link to this message

Spatten1
Posted on Wednesday, July 12, 2006 - 02:37 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Mine's way out of warranty. Bummer.
Top of pagePrevious messageNext messageBottom of page Link to this message

Spatten1
Posted on Wednesday, July 12, 2006 - 02:38 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Thanks for sharing your riding habits, any info is good to know right now.

I hope this gasket holds forever for you.
Top of pagePrevious messageNext messageBottom of page Link to this message

Jasonxb12s
Posted on Wednesday, July 12, 2006 - 09:17 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

My rear base leaked at approx 10k miles. I alway warmed it up too. I make sure to take it easy until I'm at least 5 miles down the road now. No problems since.
Top of pagePrevious messageNext messageBottom of page Link to this message

Buellfirebolt31
Posted on Wednesday, July 12, 2006 - 11:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

i'm not going to lie....i'm always late to work and i don't always let it warm up fully....but no probs for me (knock on wood) but i f so i have good ole' HD 2 year warranty...plus i work at the harley shop....
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration