| Author | Message | ||
     Buelltroll |
In the pic I'm pointing to a little rubber grommet/washer. I recently replaced the collar next to my finger and I'm wondering if this is normal. The washer is all loose is it supposed o be like that? I don't remember seeing it when i replaced the collar so I'm HOPING its not supposed to be on the INSIDE.  | ||
| Skully |
Mine is on the outside just like yours. Keith | ||
| Buelltroll |
Ya nvm people. I just went out n loosened the bolts tapped it over a little n seems right now. Now I'm gonna go flog it for a while on my scary bald tires. (Message edited by buelltroll on May 23, 2006) | ||
| Yeags30 |
that is suppossed to be there....mine has it too  ) | ||
| Skyguy |
I think it is supposed to be pushed tight against the shaft seal in the primary. I looked at a new Buell and it was snug. Maybe the heat causes it to expand and move away a bit. I used a touch of high temp silicone to put it back where it belongs as I figured it is protection for the shaft seal. Either that or the factory got a great deal on a bunch of rubber rings and that was the only place they could find to use them. |
