| Author | Message | ||
     Xblake |
Does anyone have a PC II-III map that they would recommend? OR any advice on what would be a good map to run?? I have a 03 xb9s with a K&N, 12-lid, and Jardine slip-on. Thanks... | ||
| Americanmadexb |
i didnt even know they made them for Buells. i emailed them and they said they dont make um. Did you get one for the Sportster? where at? | ||
| Buelltroll |
You need a map for THAT setup. The only real way to tune a pc3 is on a dyno thats when you make your own map for your setup. There are a couple of maps floating around but I don't think they were with a Jardine pipe. | ||
| Xblake |
Americanmadexb I think that the power commander was actually for a S1 or M1 but they work on the XBs. Some people have mixed feelings on this. I had mine on my bike for maybe 6 weeks and every thing seems ok. | ||
| Buelldyno_guy |
I can MAP a X1,S3,or XB, but the correct way to go on an XB is Direct Link. Xblake is you get one here is a good place to start, without the use of a dyno. Down load an 803-000s MAP into the PC. The "S" means you have the DJ wide band 02 sensor and you will need it. the "803" is a Buell PC and the "000" is a Zero MAP. That means no changes from stock, but you will need to go into the DJ control software and offset the 02 reading to "1' which will be richer. Now ride the bike in closed loop so the AFV will set itself allowing the ECM to skew any lean conditions just a little richer. If you can get to a DJ Tuning Center that has "Tuning Link" start with the same map, but tune above 3K and 40 % throttle "Open Loop" to 13.5:1 with the 02 sensor disconnected and the AFV reset. Hook the 02 back up and go ride it will work great. I charge about $325 to tune a Buell with a PC, because it takes several hours. I worked this idea out at Dyno Jet during a training session with a DJ Tech Support guy and have done many Buells this way. ... Hope this was no too confusing. ... Terry PS regardless of the P/N all Buell PC3s are the same do worry about the X1 - S3 P/N differences and they will work on a XB, but DL is a much beter way to go. ... TP |
