Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Mountainbiker90
| Posted on Friday, February 17, 2006 - 09:47 pm: |
|
I have an 04 w/a factory race ecm. The bike is in parts and i'm putting it all back together. there is one wire that is grouped w/those that connect to the ecm. it is a sole wire by itself with a female plug on it encased in a black plastic sleeve (it looks similar to the ones going to the horn). it looks like it was attached to a male connector, but i can't find one. any ideas? thanks in advance. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Fullpower
| Posted on Friday, February 17, 2006 - 10:04 pm: |
|
the ECM from the XB12 has a 1/4" male blade connector in the middle between the black and grey connectors. it is for the interactive muffler servo. you may disregard that wire. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Mountainbiker90
| Posted on Friday, February 17, 2006 - 10:21 pm: |
|
thanks for the quick info. makes sense. hope to get it going tomorrow! |
|