Author |
Message |
T9r
| Posted on Thursday, September 22, 2005 - 09:26 am: |
|
What diameter are the bolts holding the front rotor to the rim? Are they 3/8" or smaller? Got a length as well? I know I'm asking a lot here~ |
New12r
| Posted on Thursday, September 22, 2005 - 08:55 pm: |
|
May I ask why, I would buy a new Hardware Kit from the dealer, Trust me!!! |
M1combat
| Posted on Thursday, September 22, 2005 - 11:29 pm: |
|
Probably a good idea. I think those bolts are somewhat specialized. |
Lpowel02
| Posted on Thursday, September 22, 2005 - 11:36 pm: |
|
funny coincidence...I just replaced my front rotor last night...go with the hardware kit...the bolts come coated with a locking compound...part of the reason the manual says new bolts each time |
Lpowel02
| Posted on Thursday, September 22, 2005 - 11:37 pm: |
|
but to answer your actual questions... ...I don't know what size/length they are |
T9r
| Posted on Friday, September 23, 2005 - 09:15 am: |
|
Purpose: I was thinking of using them on another application on the bike, in mounting axle sliders. |
New12r
| Posted on Friday, September 23, 2005 - 10:37 pm: |
|
Were you going to use rubber on the backside like a bar end? I will measure the bolts and post in the A.M. but they are not very long. |
T9r
| Posted on Monday, September 26, 2005 - 11:45 am: |
|
I connected them to a rod that ran thru the whole axle to the other side. See another post: http://www.badweatherbikers.com/buell/messages/32777/148545.html?1127631743 |