| Author | Message | ||
     Coyote_xb12s |
Could someone please post a picture of the fuel pump connection for an 12R? I am not getting the initial prime at the turn on the start switch and just want to make sure everything is clean and hooked up properly. Thank you. | ||
| Tomzweifel |
Do you have a voltmeter? With the key to on and the run switch in run, you should have battery voltage present at pin D on the fuel pump connector. When you put the run switch to run, you should have a ground connection present through the ECM at pin C for two seconds. How does that check so far? (Message edited by tomzweifel on June 26, 2005) |
