|Posted on Monday, June 19, 2017 - 03:18 pm: ||
I have a new to me 2010 and just started to notice seems clutch starting to slip in 4-6 gears over 7300RPM.
Bike has a slight weep from clutch side (typ at the Puck). and am I am planning to do a
Click to view larger image and other views
X2086-1AM Buell Hydraulic Clutch Piston amp Cylinder Kit.
Is there a better choice or aftermarket alternative?
|Posted on Monday, June 19, 2017 - 03:54 pm: ||
If it's more expensive, it's because it is an entire assembly, like a pre-assembled kit. It's very nice.
|Posted on Monday, June 19, 2017 - 03:55 pm: ||
Yes. Erik Buell Racing has an improved kit. They may have some left over that they are selling off. I suggest you call and ask.
|Posted on Monday, June 19, 2017 - 07:08 pm: ||
But I doubt that is causing the clutch to slip; leaking piston would make it difficult to shift, especially downshift at speed and 1st gear at a stop.
|Posted on Monday, June 19, 2017 - 07:46 pm: ||
All the kits mentioned above will do the trick, I got the x2086.1am kit on my 08 and the EBR kit on 09. Since you are in Canada, the Oberon kit is likely easier to source than the EBR or Buell kits.
|Posted on Monday, June 19, 2017 - 09:39 pm: ||
like Joe7 sez...the leaking slave cylinder won't make it slip...
Barnett makes a kit for the 1125
a) don't use the springs included in the kit...they are very stiff...just replace the "stock" springs
b) soak the plates overnight before you install
c) pay attention to the order of the steel plates...I believe the first one to go in (or last one to come out) is different from the other plates (which are all alike)