|Posted on Sunday, April 30, 2017 - 10:34 am: ||
Seems I remember seeing these on EBR's web site a while back, but they were out of stock.
They apparently were removed from the web site at some point.
Just to be clear, these were molded plastic (of some sort) , fit in the holes in the front of the fairing after the headlights are removed for racing.
As I recall, they had lips around the perimeter so they could be fastened in place either with screws or pop rivets.
Anyone know of a source?
Anyone have a set to sell?
|Posted on Sunday, April 30, 2017 - 02:08 pm: ||
following this, also interested
|Posted on Monday, May 01, 2017 - 11:56 am: ||
I have a pair I bought so I could pull the head light assembly when I go to the track.They are permanently installed so I bought another fairing for the track.If I had it to do over again I would just buy a fairing for the track and use my stock one for the street.It would probably be cheaper too.
|Posted on Monday, May 01, 2017 - 02:10 pm: ||
In the direction Nm5150 was talking.
Thought maybe they would have the fillers also, but they do not.
Catalyst is what I have on my race bike.
They offer both street and race products, they can probably make you something specific also.
|Posted on Wednesday, May 03, 2017 - 10:07 pm: ||
^^^ Thanks. I have a set of their front, side, and belly fairings on my R, but they have the cutouts for the lights.
I have a neighbor who is extremely talented with composites. I think I'll call in a favor, and have him make me some plugs.
|Posted on Thursday, May 04, 2017 - 08:18 am: ||
Use your headlights to make the molds...
|Posted on Thursday, May 04, 2017 - 04:09 pm: ||
Thanks. That's what I had in mind suggesting to him.