|Posted on Saturday, October 17, 2015 - 01:11 pm: ||
When I was pulling codes in diagnostic mode. I noticed under the clutch state it was 0. Saw in the manual it can be 0 or 1,but really not sure if that's good bad or indifferent?
|Posted on Saturday, October 17, 2015 - 03:58 pm: ||
Pull the clutch in and it changes the state, I've used it for determining where the friction point is when adjusting the clutch.
|Posted on Saturday, October 17, 2015 - 04:49 pm: ||
There is a switch on the clutch control that tells the ECM whether the clutch is engaged or disengaged.
It helps prevent the starter from operating when the transmission is in gear and the clutch lever is released.
(I didn't say engaged/disengaged in the second sentence, as the manual uses the terms opposite the way I always have...)