| Author | Message | ||
     Shawns |
I found an vacuum sensor of sorts just behind the airbox with no vacuum line attached. Any Ideas? | ||
| Two_seasons |
Yes, I believe that is the solenoid that controls full on throttle in 3rd gear. The previous owner must have "de=noided" it. This was an EPA requirement that Buell had to meet to sell that bike. | ||
| Shawns |
Forget my stupidity, what do you mean by de=noided? | ||
| Bartone |
The removal of the solenoid that would force shut the valves at a particular rpm range in 3rd gear (IIRC). It would later then release and allow the valves to open and this caused an unexpected blip of power as you are accelerating. | ||
| Ohsoslow |
its probably your baro sensor, does it have a nipple on one end with an oring on it? | ||
| Shawns |
Yes it Does | ||
| Stirz007 |
Barometric sensor only has wired connection - so you aren't missing a hose - good to go. | ||
| Jcjohnson33 |
And it clips into the base of the airbox and has a hole that is brass lined? If so than ohsoslow is correct its the baro sensor | ||
| Shawns |
Nope no Brass Lining, it does clip in the back edge of the airbox with a green o-ring. | ||
| Kruizen |
Baro sensor, make sure it clips so the nipple is kind of pointed down/sideways. | ||
| 1125rcya |
 | ||
| Shawns |
Yep thats the one. | ||
| Ohsoslow |
yup, just make sure is it sitting in the clip like pictured. |
