| Author | Message | ||
     Nillaice |
i got a motor from EBR and the clutch cover doesn't have a hole inside the dipstick for the banjo bolt to install the clutch vent tube.  vent tube  old cover  new cover i'm not really sure if i should re-use an '08 clutch cover (with the weeping water pump) or if i should plug the vent tube at the head and run with out it. | ||
| Stirz007 |
Plug the barb fitting at the head. (Top end of oil line connection). Ditch exterior oil line. Good to go. | ||
| Nillaice |
will do. thanks! | ||
| Avalaugh |
So why has this change happened between the years ? What's the benefits please. | ||
| Nillaice |
come to find out; It’s a just a vent to aid oil fill. they eliminated it in ’09, as it didn’t really do much. | ||
| Kruizen |
My 09 has it | ||
| Nillaice |
so did my OH9. i'm guessing it was revised in 09 and didn't fall into effect until the '10 models | ||
| Kruizen |
Do you have the oil check window? | ||
| Nillaice |
nope. wish i did |
