| Author | Message | ||
     Russmannnn |
 The are the bar ends that are available on Buell Parts.They are 16.00 and most others are 30.00 or more. I just don't know if they are too cheep or a good buy. | ||
| D_adams |
Yes, but I used a longer bolt on the throttle side and added about 1/2" of flat washers to space the rubber farther into the bar. It helps with the vibes a little, but not a lot. | ||
| Zac4mac |
Those are the same ones I got for Loretta. They were 10 bucks at a metric shop. They are light so I put some birdshot in a bag in each bar that kills the buzz.  I made my own ends, used the guts from the ones above.  Z | ||
| Trojan |
They are pretty standard chinese made bar ends with very poor anodised finish. If you just want cheap bar ends shop around as you can get these for peanuts. If you want 'decent' ones then look elsewhere. | ||
| Noone1569 |
I have them. From the shop that runs Buell Parts. Not bad at all. I had no issues mounting them. They are light, but loads heavier than the stock ones. Probably will do the birdshot mod later. |
