| Author | Message | ||
     Georgehitch17 |
Hey guys I just put this setup on overall I am very satisfied but I have a couple questions!! TPS reset procedure: Do I just turn the key to on and go from closed to wide open on the throttle three times The bike stall a few times at a stand still when I was playing with the gas? Could this be because its still learning the a/f values???? | ||
| D_adams |
Key on, open/close 3x, key off. Don't play with the gas for 10 minutes, the IAC needs to average out. AFV's should not change, it's a race ecm. | ||
| Fran_dog |
Copied from first link below. 1st) TPS re-set 1) Turn the key on and make sure kill switch is on run. Leave this way until step 6. 2) Do not start bike. 3) Turn throttle to full open and hold about one second. 4) Release throttle completely so it snaps shut. Wait one second. 5) Repeat the steps 3 and 4 (full throttle, hold and release) two more times. 6) Turn the key off for at least two seconds. 7) Then you can turn on and start. 2nd) IAC averaging re-set Start bike and let it idle for ten minutes. http://www.badweatherbikers.com/buell/messages/290 431/600270.html http://www.badweatherbikers.com/buell/messages/290 431/566368.html} (Message edited by Fran_dog on August 16, 2011) | ||
| Georgehitch17 |
Thanks guys!! |
