G oog le Buell 1125R Forum | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » 1125R Superbike Board » Archives 001 » Archive through January 24, 2011 » Aftermarket turn signals « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Duphuckincati
Posted on Friday, January 14, 2011 - 01:37 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Wanting to fit some smaller or flush mount turn-signals, (and bar-end mirror) hopefully ones that just wire them up and go, i.e. no additional relays or such. Any recommendations?
Top of pagePrevious messageNext messageBottom of page Link to this message

Wild1
Posted on Friday, January 14, 2011 - 03:00 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I installed small turn signals to the front of my 1125cr and better mirrors.

Top of pagePrevious messageNext messageBottom of page Link to this message

Rogue_biker
Posted on Friday, January 14, 2011 - 03:15 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I think some aftermarket signals you have to replace and solder the connecting half of your OEM signal wires. The OEM male/female connectors look larger than the ones that come with aftermarket signals.
Top of pagePrevious messageNext messageBottom of page Link to this message

Drhodes1970
Posted on Friday, January 14, 2011 - 03:25 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Wild1-I like your tail bag. Which one is that? And where did you get it? Duphukincati- I have the Oberon indicators and mirror comboand love them .They just look like they belong on the bike. Alittle on the expensive side though.Go to their site and check them out .I'msure you'll like them.
Top of pagePrevious messageNext messageBottom of page Link to this message

Ratbuell
Posted on Friday, January 14, 2011 - 06:02 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

If anyone has good working CR mirrors they're not using, let me know. I have them on my Uly, CR (duh), and M2L. Love em. Always looking for spares (and could use a set for the S1W)!
Top of pagePrevious messageNext messageBottom of page Link to this message

Jetbuilder
Posted on Friday, January 14, 2011 - 06:42 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Cant speak for the CR but on my "R" I simply cut the leads going too the mirror/signals and rerouted them to power the outboard lights in the fairing and put yellow bulbs in place of the white ones.
R
Top of pagePrevious messageNext messageBottom of page Link to this message

Wild1
Posted on Friday, January 14, 2011 - 06:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

The tail bag is off my XB12r. The tail sections as with the airbox cover is the same.
Top of pagePrevious messageNext messageBottom of page Link to this message

Wild1
Posted on Friday, January 14, 2011 - 07:00 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

As far as the wiring goes, I went to the local electrical shop and took the stock blinkers down to match up the plugs and crimped them on. The new blinkers are just under the slots on the side of headlight plastic.

(Message edited by wild1 on January 14, 2011)
Top of pagePrevious messageNext messageBottom of page Link to this message

Djruffryd
Posted on Friday, January 14, 2011 - 08:24 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Found this:

http://www.youtube.com/watch?v=sLVW2xRzakA

Hope it helps.
Top of pagePrevious messageNext messageBottom of page Link to this message

Duphuckincati
Posted on Friday, January 14, 2011 - 09:14 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Thanks for the replies. The one thing I was wondering was the compatibility for the draw to aftermarket signals. As you can see in the video his seem to flash pretty rapidly. At first I thought he did not have the rears hooked up yet. No big deal, just enough for a LEO to wonder the same.
Top of pagePrevious messageNext messageBottom of page Link to this message

Kc10_fe
Posted on Friday, January 14, 2011 - 10:09 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Rizomas and CRG mirrors






« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration