Author |
Message |
Crazyhawk99
| Posted on Tuesday, October 12, 2010 - 04:35 am: |
|
Does anyone know what size and thread pitch the motor mount bolts are? I am talking about the ones just aft of the pods. I am installing frame sliders and the provided bolts are too long. I need to cut approx 1/8-1/4 inch off, but first I want to run a die on them so I can clean the cut threads afterward. I have an 80 piece tap and die set, but I can't seem to get any of my dies to easily thread on. At this point, I am not even sure if it is metric or SAE. I know this must sound pretty stupid, but it is quite frustrating. Thanks in advance! |
|