Author |
Message |
Avalaugh
| Posted on Saturday, July 03, 2010 - 03:39 am: |
|
A few weeks ago i low sided my bike, the right hand indicators were ripped off, i have new one's on order, but if i plug my left side one's in they dont work, on either side and nor does the IC light flash when they are turned on ? Does it need all 4 to create a circuit or is something else broken here ? i have checked for damage etc and can find nothing. is there a fuse specific to the indicators as i cant find that either ? |
Craiga
| Posted on Saturday, July 03, 2010 - 09:59 am: |
|
Somethin else is broken it sounds like, the directional lights on the IC should flash, faster if nothing is connected, with or without wires hooked up. |
Lastonetherebuys
| Posted on Saturday, July 03, 2010 - 10:07 am: |
|
I don't know where to start looking for your problem but there is deffinatly something else wrong there. When I first got my 1125 it got backed into in a parking lot and broke both the left mirror and left rear signal right side signals worked fine. Just recently I was playing around ant dropped it on the right side and broke the mirror all other 3 signals work fine. |
Dktechguy112
| Posted on Saturday, July 03, 2010 - 12:46 pm: |
|
check the ic connector, mine was loose and the turn signals were not working. The ic controls the turn signals, so check it first. Especially if you are not getting the turnsignal lights on the ic. |
Lastonetherebuys
| Posted on Saturday, July 03, 2010 - 01:14 pm: |
|
was just thinking i know its on the wrong side but if it got bumped hard enough in the low side crash a conector could have come loose in the signal switch and the switch isnt sending a signal to the IC any more. |
Avalaugh
| Posted on Sunday, July 04, 2010 - 07:42 am: |
|
Fixed now, i stripped back part of the loom and found a broken wire that had been damaged in the crash, but it wasn't exposed which is why i missed it. |
|