| Author | Message | ||
     Hogzilla |
Sorry if this is a repeat. What size bulbs go into the rear turn signals. All I can find are the HD/Buell part numbers. Thanks! | ||
| No_rice |
i thought they were an led circuit board?? but what do i know ive never even made mine blink before they got taken off | ||
| Boogiman1981 |
yup surface mounted led's three i think | ||
| Hogzilla |
I'll look again tonight. Could have sworn the rear turn signals were halogens. Manual shows 10 watt with a part number of Y0042.K. I want to put red LEDs or a red halogen in and with the Kisan tailBlazer turn the tail light and turn signals into brake/running lights. | ||
| Lastonetherebuys |
they most deff are an LED board in there. If you want to go red there are tons of better aftermarket bulbs out there | ||
| Avc8130 |
If he has a 2010 it would be a bulb... ac | ||
| Hogzilla |
Sorry guys, Avc8130 made a good observation. I have a 2010. | ||
| No_rice |
hmm, they back tracked from led to bulb? didnt notice that... (Message edited by no_rice on January 21, 2010) | ||
| Hogzilla |
Yeah, they did a swap, bulb tail light to LED, and LED turn signals for bulb. Go figure. | ||
| Ratbuell |
Just get OEM '09 LED signals. They got the bugs worked out after the '08s; replacements and '09s work just fine. | ||
| Moosestang |
Just get some aftermarket led signals. | ||
| Mountainstorm |
Have you checked the blinker fluid? The Buell techs didn't fill mine and luckily I noticed before it burned out the bulb. | ||
| Hogzilla |
They filled it with Genuine Harley Davidson Synthetic Blinker FluidŽ. I don't want premature wear on my blinkers. | ||
| Milt |
According the shop manual, you have to rotate the engine to get to the blinker fluid reservoir.  | ||
| Zac4mac |
I would think you'd need a ballast resistor to use the LEDs on a 2010 model. AFAIK the only difference in a 2009 and a 2010 IC is the flasher drivers. Z | ||
| Henessey |
The part # for the 2010 turn signal bulb is Y0042.7AA Amber RY10W |
