| Author | Message | ||
     Cataract2 |
Ok, just got me 08 1125R flashed from 05Z to 062. I've only ridden it a short distance being that I'm recovering from surgery (just around the apartment, like from where my fiance and I offloaded it from the truck to my garage). Well, I noticed I was getting the check engine light briefly >4 seconds and it would go off. I checked the codes in diag mode and it was showing ECM Error P----, TPS Error, Fuel Sys Error, Tipover Error, IAT Error, Baro Error, etc. I was wondering if that was normal after a flash update. Like I stated, the bike starts and runs fine for the short bit I rode it. I'm currently disassembling my bike right now for the valve clearance check. (Message edited by cataract2 on January 04, 2010) | ||
| Moosestang |
That is normal. They are supposed to clear the codes after the flash. You can clear them yourself if you have ecmspy. | ||
| Milleniumx1 |
Those will appear on a reflash if the dealer doesn't clear the codes - Just like Moose said. Are you close by the servicing dealer? Mike |
