| Author |
Message |
    
Zracer196
| | Posted on Friday, October 30, 2009 - 08:59 pm: | 
|
I am with you AVC...My bikes harness BARELY makes it into the subframe... |
Dmhines
| | Posted on Friday, October 30, 2009 - 09:20 pm: |
|
FYI .. my CR did have the later generation rear flashers with the White Tape stripe on them. Maybe they are longer. Are you guys with problems installing on a 2008 bike? |
Dbolemiss
| | Posted on Friday, October 30, 2009 - 10:09 pm: |
|
So where is the best deal on these? I've found them for around $73 shipped.Any site sponsors doing it for that or better? |
Dmhines
| | Posted on Friday, October 30, 2009 - 10:16 pm: |
|
Got mine on eBay for $65 shipped. |
Dbolemiss
| | Posted on Friday, October 30, 2009 - 10:45 pm: |
|
Found it,thanks |
Palerider
| | Posted on Saturday, October 31, 2009 - 12:23 am: |
|
I had the same problem with the wires not reaching on an "08 and I found just as Marcodesade said and it was fine. And they had the white tape.
Also the white tape on the wires mean nothing. As Court stated, the blinkers with the grey sealant inside are supposed to be the newer ones, if I remember correctly. |
Rah7777777
| | Posted on Saturday, October 31, 2009 - 12:33 am: |
|
Only thing that would make it better is a nice new crazy bright LED light..........
like these...www.xblights.com
 |
Zracer196
| | Posted on Saturday, October 31, 2009 - 08:32 am: |
|
Mine is an 08' too...Maybe that is the issue. |
Zac4mac
| | Posted on Saturday, October 31, 2009 - 08:42 am: |
|
When I contacted Robert at XBLights about a light for my 1125R, it was the first one he did.
I pulled the rear plastic and took pix and measurements and connector types for him.
When he got the light done and sent to me, it slid into place and "just worked".
Z |
Ridegreen2oo
| | Posted on Saturday, October 31, 2009 - 10:54 am: |
|
My turn signal wires fit fine. I didn't have much extra slack, but enough for the connection |
Vosnick52
| | Posted on Saturday, October 31, 2009 - 03:20 pm: |
|
Installed mine this morning and it looks and works great. |
Ridegreen2oo
| | Posted on Saturday, October 31, 2009 - 03:28 pm: |
|
If you don't want to cut away the plastic under the tail to get some light on your license plate, check these out.
http://www.amazon.com/gp/product/B001EUQLZI
you just have to do your own wiring but they work great. I also had to take a file to the bolt holes on the fender eliminator to make the bolts fit. I managed to find a site that had them on special and i think after shipping I only paid around $10.
If any of the sponsors carry them I'll change the link to theirs. |
