| Author | Message | ||
     Rigid_frame |
i got a buddy of mine that says you might be able to trick the ecm by putting the sensor outside,and block off where the sensor goes.my question is has anybody tried this and do you know where the sensor is located on the motor? | ||
| Boogiman1981 |
it would never get into closed loop mode. could possibly foul plugs due to over rich and would likely through a code if the sending unit isn't grounded correctly | ||
| 1_mike |
Rigid - Why would you want to do this...? There are much better was of tuning than hacking like this. How would you know if you were running HOT and needed to stop and look into a given problem? MIke | ||
| Cataract2 |
Um, do what? | ||
| Rigid_frame |
wasnt really planning on doing this would rather get a programmer, was just wondering if anybody else tried this, i apperciate the help |
