| Author | Message | ||
     Bartman1 |
hello everyone, so I after a long winter up here in Maine, I have my 1125r up on the lift and am doing spring cleaning. Had her at the dealer for 4th flash in jan. Have not run it since. I noticed today that my o2 sensor above my front tire, the wire comes out of the top of the sensor does not go anywhere?? Has a plug on it but no place to plug in??? WTF?? Called dealer, as always... No clue,no help. could someone please help me out? | ||
| Sharkytattoo |
Look above where the header pipe bolts to the head. There is an air scoop, and the front O2 sensor plug is on top of the scoop. Kind of hard to see, but its there. Hope this helps. | ||
| Bartman1 |
yep, it was there. I didn't even get a check engine light? pluged it in. Hope all is good.... thanks! anyone else had this issue?? | ||
| Bartman1 |
I think this might have never been hooked up at all?? I only have 1300 miles, (#454) and I don't think it was ever hooked up?? Does that make sense?? Would I have thrown a code if it had been unplugged from the dealer?? I plugged it in today but am concerned that it has not been installed at all? Unfounded?? Anyone had this happen? I had my 4th flash in jan, and I don't think it was installed then. Also my dealer installed my vent hose through my passengers footpeg, they broke the two bolts and siliconed it on... Fell off today.. Very nice... Any input would be appreciated. | ||
| Bigblock |
Call Buell customer service... | ||
| Jmr1283 |
central maine? thats disappointing. jeeze siliconed it on! u wouldnt necessarily throw a code within 1300 miles. i forget the amount xb9 went with his unplugged but im pretty sure it was like 1600 or so. I would just unplug them. all it does is throw codes doesnt hurt anything. but better yet go to •••• youll get lots of info. (Message edited by blake on September 14, 2009) |
