| Author | Message | ||
     Jmr1283 |
I put the heating elements on and then put epoxy on the bar and throttle. attempted to slid the grib on and for the best of me i couldnt do it. very frustrating. is there a trick? also i pulled of my pod and notice zero coolent in the expansion tank.. it only has 900 miles. so i guess the factory doesnt like to fill it up. now i have to purge the system. damn.... anyway back to my ?. any help would be greatly appreciated. | ||
| Slypiranna |
Use a shot out of a compressed air gun at the end of any new throttle grip install... ...they go on like butter. I prefer hairspray for grips over any glue but thats just me. Top off the rad (when totally cooled down) and then overflow and recheck in a day or two, she might have sucked it back in during your new bursts of pleasure!  | ||
| Redscuell |
I do the hairspray thing, too -- but I spray it inside the grip then push it onto the handlebar while still wet. Get it into position in a hurry, though! To remove, spray wd40 (use the 'straw) inside the installed grip. Both are very old tricks from the days of pushbikes.  |
