| Author | Message | ||
     Gamdh |
I am the original owner,bike has 79,019 miles and I'm still riding it when not on the '10 Uly. Still runs good, just needs a new home. Has the following mods: OEM Race Kit (XB Race Muffler and XB Race ECM) XOpti eeprom upgrade K&N Air Filter 07 Inner Airbox cover Traxxion Dynamics Fork Spring Kit Breather Re-route Parabellum 16" windscreen (still have stock windshield) Clearwater Lights LEDs (Glenda's) Madstad Adjustable Windshield System with metal fly screen (still have stock plastic flyscreen) HVMP Bar Ends Quick-Lock Tank ring on air box (no tank bag) Comfort Kit Fehling Rear Rack Centech AP-2 fuse block under fly screen (with Eastern Beaver wiring harness) Special-OPS Uly maximum seat barrier (front section only) 2010 Rear Wheel (still have original wheel and axle with upgraded bearings) DDMTuning HID (Low Beam) (low beam pin switch for both lights on with high beam) Fatty's voltage meter mod Service and Parts manuals Airbox is worn/scuffed from tank bags etc. The original 'Buell' stickers came off, but I still have them. Bike has 79K miles, so it has been ridden, definitely not a 10. The full Disclosure part: The last couple of times I rode it, the HID went out once or twice. I finally figured out the voltage meter indicated a high voltage condition and the HID circuitry shut off the HID to protect it, the condition was very brief and has not happened every time. However, I'm thinking the VR and/or Stator need to be replaced. The original VR/Stator were replaced around 33K miles, so based on that, its a good guess. Parts for that are $300-$350 from Al @American Sport Bike. So, I kind of factored that into the asking price....I can replace them again, but would probably raise the price a bit. Figured I'd post here first and see if anyone was interested and to get any feedback before posting else where. Contact me via PM or eMail 'mdhopkins07 at gmail dot com' Pics at Link below Bike needs to be washed... just did a quick wipe down for these pics. http://gamdh.smugmug.com/Motorcycles/20150409-06-Uly If you want pics of something specific, let me know. Also..2 things I noticed while taking pics that I had forgotten about. 1. On the front of the air box, in 2 spots are left over attachment points (adhesive backed velcro) from an old Toura-TEch tank bag. 2. Looking at the front of the bike the middle right screw on the fly screen is stripped. Been that way for a long time and with the metal fly screen, never really worried about tapping it to the next size. (Message edited by gamdh on April 09, 2015) (Message edited by gamdh on April 09, 2015) (Message edited by gamdh on April 09, 2015) | ||
| Dammitquikgentry |
Pm sent | ||
| Gamdh |
got it, responded to your pm | ||
| Jrobey7 |
I'll take it paypal ready, PM sent | ||
| Gamdh |
jrobey7 got your pm.... still talking with Dammitquikgenry...but your next in line of that falls through | ||
| Gamdh |
Added pics of the following extras to the gallery link above Rear Master Cylinder Rebuild Copper Crush washers Tootal's throttle body shaft Banjo cover gasket Primary inspection cover gasket Shift Shaft Seal Front wheel spacer tube Front wheel bearings Upgraded steering head wire router Plug wires Cooling fan Intake seals 06 Wheel with Updated bearings 06 Axle Stock Fly screen Stock Wind shield Head light harness - has hole for HID install Head light assembly....the bolt that receives the screw from under the fender is stripped in the plastic | ||
| Jrobey7 |
Yep that's mine | ||
| Gamdh |
Sold! | ||
| Jrobey7 |
Received bike and parts! Ecstatic with the quick communication of the seller and condition of the bike/parts. Don't come across too many stand up people as Mr. Hopkins! Hope you get back into Buells someday. Another great example of a higher mileage XB in what I'd term perfect condition for it's use. I hope people Don't shy away just cause mileage in the future. (Message edited by Jrobey7 on April 26, 2015) |
