G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » Buell Motorcycle Classifieds » Buell Parts & Accessories for Sale » Archive through March 13, 2009 » Blast and Tuber parts. « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Thursday, December 04, 2008 - 03:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

i have some parts in the garage that need a good home, to help me finance a drummer or special ops muffler! all parts are OBO plus freight. i may consider some trades, i need a white blast front fender, a Uly Drummer or Special Ops Muffler, S1w single seat and tail section. please make offers. i may not get back to you immediately, and it will take me a little while to get a freight quote. please be patient. thanks.

1) Red Blast tank cover, good condition, victim of "driveway drop" from previous owner. $50.00














2) Red Blast tail section, good condition, slight scuff on side, should polish out, mounting holes have small splits. $50.00












3) Orange M2,S3,S1 tank for carb'd tuber, i bought this tank off of ebay, it was not quite as good as it looked, it is a non factory repaint, serviceable but has some bubbles and flaked paint, would work as is for a daily driver or repaint. i found a better one a few months later. no petcock or vent, has locking cap. $100.00










4) i believe a Force pipe, silver, i think it was on a 99 M2, there is no O2 bung, has surface rust, needs blasting and recoating or wrapping to look good. $150.00












5) Blast low seat, very good condition, hardly ever used, no tears or scuffs, has latch pin. $50.00








6) M2 seat, (don't know for sure if it's for a low, tag says 99 M2), pretty good condition, has very small tears at front edges, barely visible, also someone put some type of clear RTV sealant on the seam at the bottom of the front, no idea why, no latch pin. $50.00











(Message edited by sleez on December 04, 2008)

(Message edited by sleez on December 04, 2008)
Top of pagePrevious messageNext messageBottom of page Link to this message

Brinnutz
Posted on Thursday, December 04, 2008 - 04:11 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

sealant is on there because the tape that was there fell off. There are stalples under that rtv. it's to protect the tank from getting scratched.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Thursday, December 04, 2008 - 04:18 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

thanks Brinnutz, someone passed the seat on to me because he knew i had buells.
Top of pagePrevious messageNext messageBottom of page Link to this message

Kalali
Posted on Friday, December 05, 2008 - 11:41 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Will that M2 seat fit an X1?
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Friday, December 05, 2008 - 12:09 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Kalali;

i don't think so, pretty sure not, unless you change the rear bodywork to the m2 style, the tank interface would be a bit different as well.

but maybe someone with both could try it??? i really doubt it would work though.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Saturday, December 06, 2008 - 11:51 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Blast bodywork sale pending.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Tuesday, December 09, 2008 - 06:56 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

blast body work sold pending payment.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Wednesday, December 24, 2008 - 06:02 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

bump for Xmas
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Wednesday, December 31, 2008 - 06:30 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

blast body work sold and shipped.

thanks.
Top of pagePrevious messageNext messageBottom of page Link to this message

Basti
Posted on Friday, January 09, 2009 - 02:16 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Hi
do you still have the tank ? If so Im very interested, please send me a mail : s.gschossmann@freenet.de
thanks
Basti
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Friday, January 09, 2009 - 02:33 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

basti,

yes i do, will email you.
Top of pagePrevious messageNext messageBottom of page Link to this message

Doublej
Posted on Saturday, January 24, 2009 - 09:35 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Do you have the blast low seat still?
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Saturday, January 24, 2009 - 11:22 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

yes, i still have the seat.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Saturday, January 24, 2009 - 05:11 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

blast seat sale pending.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Thursday, February 12, 2009 - 06:09 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

blast seat sold and shipped.

still have the tank and pipe, M2 seat listed on ebay;

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?Vi ewItem&item=280312861552&sspagename=STRK%3AMESELX% 3AIT&viewitem=#ht_500wt_1613
Top of pagePrevious messageNext messageBottom of page Link to this message

Trouble_enabler
Posted on Thursday, February 12, 2009 - 06:17 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

PM Sent for exhaust
Top of pagePrevious messageNext messageBottom of page Link to this message

Trouble_enabler
Posted on Thursday, February 12, 2009 - 07:15 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Exhaust does not look like it will fit my S3, thanks for the info!
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Thursday, February 12, 2009 - 07:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

it looks to be for a 99 and later tuber, but has no bung for O2 sensor, so M2 i guess, or add the bung, or remove the FI!!!
Top of pagePrevious messageNext messageBottom of page Link to this message

Lovedabueller
Posted on Thursday, February 12, 2009 - 08:24 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

is that a rust hole in the bottom of that pipe in the muffler.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Thursday, February 12, 2009 - 08:27 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

no holes, just surface.

if it doesn't sell as is, i will strip and coat it, but it will go up accordingly.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Saturday, February 14, 2009 - 08:18 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

M2 seat sold, awaiting funds.
Top of pagePrevious messageNext messageBottom of page Link to this message

Lovedabueller
Posted on Saturday, February 14, 2009 - 09:23 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

is it for sale still.
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Saturday, February 14, 2009 - 09:36 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

keith,

the pipe is still for sale, i was planning on sand blasting it when we get some dry weather, then trying to sell it, and if it doesn't sell bare, i was planning on spraying it with some hi-temp paint and trying to sell it again. if it doesn't sell then...i was planning on chucking it over a freakin' cliff!!! lol

so....yeah, it's still for sale.
Top of pagePrevious messageNext messageBottom of page Link to this message

Malott442
Posted on Monday, March 02, 2009 - 02:51 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

How much shipped to 02703 for the force pipe?
Top of pagePrevious messageNext messageBottom of page Link to this message

Sleez
Posted on Monday, March 02, 2009 - 12:11 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

hey Malott442,

i am not sure that i am still selling it, i just bought an M2 that it will fit, i need to evaluate the exhaust that is on it now. i'll keep you posted.
Top of pagePrevious messageNext messageBottom of page Link to this message

Blazin_buell
Posted on Sunday, March 08, 2009 - 10:59 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Sleez, It's been too long since I've seen an M-2 ,will that pipe fit an S-1 .If you don't use it I'm interested in it.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration