| Author | Message | ||
     Ragnagwar |
Very nice condition, no cracks, rips, fading or discoloration. Hold down nut has been replaced by a 1/4-20 nut and thumb screw and there are two very small wear spots underneath the front of the seat where it touches the tank and are not visible when on bike.$60.00 Shipped    | ||
| Big_koch |
I'm assuming the "?" means you're unsure of whether this is a low seat or not? I'm thinking about getting one to replace the seat on my standard 2K M2 but don't want to buy a clone of the seat I've already got... | ||
| Kilroy |
That definitely looks like a "low" seat. Compare the profile picture with the profile of yours. I think you will see a definite reduction in the thickness of the seat area compared to your seat. | ||
| Ragnagwar |
"Big K", I compared the seat against a brand new (stock) 1999 M2 seat, and it is exactly 1 1/2" lower than the 99 with a completely different profile. I think the question mark can be eliminated. I wasn't sure because my 2000 M2 is not a Low, but the seat was on it when I bought the bike. | ||
| Nevrenuf |
if the seat is hard than it is definitely a low seat. | ||
| Ragnagwar |
"Never" Yes, it is harder than the stocker. A lot less padding! | ||
| Big_koch |
Sounds good to me. I thought it was too but wanted to make sure. How do I send payment? | ||
| Ragnagwar |
PM Sent. | ||
| Ragnagwar |
SOLD! Thank's. |
