G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Buell Forum » Big, Bad & Dirty (Buell XB12X Ulysses Adventure Board) » Parts Interchange? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Mark_weiss
Posted on Saturday, November 06, 2021 - 12:46 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Is there a parts interchange chart somewhere on this site? I've been looking, but did not find one. I need to replace my fork seals and front wheel bearings (both are leaking). Since they are common parts, I'd like to source them locally, but would like to be able to do so before disassembly.
Top of pagePrevious messageNext messageBottom of page Link to this message

Teeps
Posted on Saturday, November 06, 2021 - 03:44 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

The bearing numbers should be etched on the outer race.

Fork parts
https://duckduckgo.com/?q=showa+43mm+fork+parts&t= opera&ia=web

(Message edited by teeps on November 06, 2021)
Top of pagePrevious messageNext messageBottom of page Link to this message

Littlebuggles
Posted on Saturday, November 06, 2021 - 04:50 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I have the bearings in my truck, when my gf gets home I can post a pic of the box or something. I believe they're an SKF part.
Top of pagePrevious messageNext messageBottom of page Link to this message

Hughlysses
Posted on Saturday, November 06, 2021 - 09:13 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Lots of wheel bearing info in this old thread:

http://www.badweatherbikers.com/buell/messages/142 838/743995.html?1318540428
Top of pagePrevious messageNext messageBottom of page Link to this message

Pitchondesign
Posted on Sunday, November 07, 2021 - 09:14 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

There is a fork rebuild kit, harley pn 49380-09. This is for 43mm showa inverted. Used on the X for 06 and 07. May work for other Ulys but I didn't check.

(Message edited by pitchondesign on November 07, 2021)
Top of pagePrevious messageNext messageBottom of page Link to this message

_buelligan_
Posted on Sunday, November 07, 2021 - 10:45 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

He has a 2008 XB12X according to his profile so I’m pretty sure he has a 47mm front end but if it’s 43mm then the fork seals are the same as all the other Harley 43mm Showa forks. Harley still sells the seals. Part number is J8127.3A8 for the Genuine Showa seal, they also have a cheaper version of the same seal but made in Thailand, part number 12085. All Harley dealers are now allowed to order Buell parts, you just sometimes have to supply them the part numbers. If you need 47mm seals they are J8127.3AK and are also still available.
Top of pagePrevious messageNext messageBottom of page Link to this message

_buelligan_
Posted on Sunday, November 07, 2021 - 11:00 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Correcting semi bad information, 49380-09 was never intended for any Buells. It is for single sided cartridge 43mm inverted forks used commonly on Harley V-Rods, Select Screaming eagle models and the XR1200 non-BPF forks. You can use most of the parts in that kit as the kit does use the same guide bushings, washer, seal clip, oil seal and dust seal. But the drain screw at the bottom of the fork are not the same nor interchangeable. That kit also does not come with any of the o-rings or plastic bushings for the upper pre-load/damper control.
Top of pagePrevious messageNext messageBottom of page Link to this message

Evilphoton
Posted on Monday, December 20, 2021 - 02:36 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

https://www.twinmotorcycles.nl/webshop/artikel.asp ?mc=1&aid=527

takes a little work flipping back and forth but it’s been great for me.
Top of pagePrevious messageNext messageBottom of page Link to this message

Hughlysses
Posted on Monday, December 27, 2021 - 09:59 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

For future reference, there’s a pretty good parts cross-reference thread on the Buell XB Forum:

https://www.buellxb.com/forum/showthread.php?26310 -Parts-cross-reference-thread
Top of pagePrevious messageNext messageBottom of page Link to this message

Mark_weiss
Posted on Saturday, January 01, 2022 - 02:17 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Great link!
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration