Author |
Message |
Kaikoura
| Posted on Monday, February 24, 2014 - 10:25 am: |
|
Good morning. I have the special wrench on order..I was able to remove 3 out of the 4 bolts easily.. The last one on intake side front head is being very stubborn,(Hence the new tool coming).. However is it safe to use MAPP gas on the head area surrounding,,my propane one just doesn't seem hot enough to break her loose.. I posted this on Tubers forum too.. All I wanted to do was replace the intake seals.. |
Kaikoura
| Posted on Monday, February 24, 2014 - 10:42 am: |
|
As silly as this sounds..can working on an engine that is located in doors unheated be a bear to work on,,especially after this winter..does the engine metal just have too much cold in it to loosen anything? |
|