| Author | Message | ||
     Electraglider_1997 |
I've got the 2010 wheel and naturally it is on the back of my ULY so I can't measure without more work than I care for when maybe I can just ask. I want to buy a wheel balance stand but want to make sure that the cones are large enough so they don't just slide through the larger 2010 bearings. Anybody able to tell me how large the bearing inside diameter is. Thanks. | ||
| Teeps |
The seal on the brake side I see 33.5 mm and 62mm. The original bearing diameter is 30mm, so if you get min 25mm max 40mm you should be covered. | ||
| Ratbuell |
The ID is the same as the earlier bearings - the axle is the same diameter, and fits in (through) the same swingarm. The **OD** is the size increase for '10. | ||
| Electraglider_1997 |
Thanks. | ||
| Electraglider_1997 |
Anyone bought one of these? http://www.discountramps.com/motorcycle-wheel-bala ncer.htm | ||
| Electraglider_1997 |
How about this. http://www.discountramps.com/motorcycle-bead-break er.htm | ||
| Natexlh1000 |
I recently bit the bullet with a cycle hill setup. Cost big bucks but it worked just fine. I recently moved away from the dealership because they stopped stocking Buell-friendly tires. I got my last tires delivered to my house from amazon.com! LOL. | ||
| Natexlh1000 |
Oh one more odd thing to bring up at this time: Wheel weights. No one sells them! I ended up buying some good quality two sided tape and using some of the old ones  | ||
| H2opatrol |
I buy weights at harbor freight | ||
| H2opatrol |
I also bought my balancer and bead breaker there. The bead breaker is kind of a PITA but the balancer works great |
