Author |
Message |
Murf2
| Posted on Thursday, October 01, 2009 - 01:57 pm: |
|
Is the Pro-Taper Raptor bar the closest aftermarket bar to the stock Uly bar? I tried searching but didn't get a conclusive answer. Thanks, Murf2 |
Thisflatearth
| Posted on Thursday, October 01, 2009 - 02:25 pm: |
|
I did some research about this time last year and posted it on ADV http://www.advrider.com/forums/showthread.php?t=38 4476 I ended up going with the Rox Risers. May upgrade bars one day, but there is so much crap on my handlebars unless they are broken it won't be worth it to disassemble. |
Maximum
| Posted on Thursday, October 01, 2009 - 04:42 pm: |
|
I use the Raptor bars on mine. They are a little lower (a little over an inch IIRC), and they are more forward because of less sweep angle (which I really like). You can get close to the stock height if you use a set of risers from PE in addition to their 1-1/8" bar adapters. I have tried both ways...and like the extra height on road trips, but love the lower height when carving through the mountains. |
Murf2
| Posted on Thursday, October 01, 2009 - 08:19 pm: |
|
Thanks for the info guys! Anyone have the part # for the stock bars? Thanks, Murf |
Johnboy777
| Posted on Thursday, October 01, 2009 - 09:43 pm: |
|
Note---I think the information below probably is close, but may not be exact- compiled from various sources... SE stands for 7/8" Width ----Height----Pull-back (sweep) STOCK--Ulysses 2007 (other years?) 762mm…….165mm…………125mm 30”-------- 6.5”-------- 5” Width ----Height----Pull-back (sweep) Pro Taper Contour Raptor..............w/ PE Fat Bar Riser = nearly stock rise (1.6" less pull-back) 770---------143-------86.5 30.3”------- 5.6--- -----3.4 Width ----Height----Pull-back (sweep) Pro Taper SE ATV HIGH…………………………..w/ plus 1” PE riser = .8 inch higher rise 813…………….160………………100 32”------ 6.3”------ 3.9” Width ----Height----Pull-back (sweep) Pro Taper SE ATV MID………………………………w/ plus 1”PE riser = .4 inch higher rise 813…………….150………………76 32”------ 5.9”------ 3” Width ----Height----Pull-back (sweep) Pro Taper SE ATV LOW………………………………w/ plus 2” ROX Buell riser = 1 inch higher rise 813…………….140………………84 32”------ 5.5”------ 3.3” (For Comparison) BMW 1200 GS Width ----Height----Pull-back (sweep) 778mm--------198mm--------92 30.6----------7.795”--------3.6” . |
Froggy
| Posted on Thursday, October 01, 2009 - 10:52 pm: |
|
N0037.4AKYBP HANDLEBAR ASSY, GRAPHITE GREY Retail Price:$74.95 2009 bars with clutch cable holder |
Murf2
| Posted on Friday, October 02, 2009 - 12:32 pm: |
|
Thanks Froggy, Johnboy777 Just what I need to know. So a stock bar would be cheaper than aftermarket because I would have to change risers with an aftermarket bar, correct? Now if I can just fins a used stock set. Thanks, Murf2 |
|