G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile Ads by Motorcycle.comMotorcycle InsuranceMotorcycle PartsMotorcycle Helmets Motorcycle Tires Buell Motorcycles

Author Message   Pontlee77 Posted on Saturday, February 07, 2009 - 05:47 am:        Hi, Any one uses fork seal savers? I saw on Touratech some made with neoprene and you fit the on with Velcro.   Dfishman Posted on Saturday, February 07, 2009 - 06:57 am:        I have some on my supermoto.I use Gibbs penetrating oil on a rag to clean my fork tubes on the Uly.It keeps the corrosion down.I feel like pits from corrosion contributes to seal failure as well as hard landings & dirt   Xbimmer Posted on Saturday, February 07, 2009 - 11:35 am:        When I first installed these with new seals 30K ago I didn't notice pitting burrs at the bottom of the right fork tube, blew the new seal in 4K. Buffed out the pits and now 25K with no problems and CLEAN forks!   Glenn Posted on Saturday, February 07, 2009 - 06:31 pm:        Hi Xbimmer, Can you put those on from the bottom or do they have to go down from the top? thanks   Pontlee77 Posted on Sunday, February 08, 2009 - 05:53 am:        Glenn, there is no way to put them from the bottom, as you have the pieces that hold the lower mudguard, and brake caliper. there is a velcro option.   Glenn Posted on Sunday, February 08, 2009 - 07:36 am:        Yeah, now its obvious   Skinstains Posted on Sunday, February 08, 2009 - 09:08 am:        I was thinking about those Velcro ones, anyone have experience with them ?   Xbimmer Posted on Sunday, February 08, 2009 - 10:23 am:        Can you put those on from the bottom or do they have to go down from the top? Theoretically you should be able to slide them down the outer fork tube, but you would probably have to remove the reflector. I installed them from the bottom, after fork disassembly when replacing the seals. Also, I used the larger size they sell (47mm?) since I didn't see how the 43mm would stretch around the outer tube. It was sold in a long version which I cut in half and fits the X fork snugly all the way to the bottom of the inner tube. In any case you have to remove the fork from the bike. Velcro types would be easier but maybe not as compliant.   Chrisp Posted on Sunday, February 08, 2009 - 06:30 pm:        I recently installed the Long Sealsavers, 1 3/4 inch (44 - 50mm fork tube), by sliding them down from the top of the fork with the fork off the bike. They slid over the reflector easily and fit snugly over the exposed portion of the fork tube. I installed them because I went to the Firebolt fender which doesn't provide quite the same protection as the stock Uly setup.

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: This is a private posting area. Only registered users and custodians may post messages here. Password: Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.) Enable HTML code in message Automatically activate URLs in message Action: